Table 83: Pppoe Intermediate Agent Commands - Edge-Core ECS3510-28T Management Manual

| Authentication Commands
C 23
HAPTER
PPPoE Intermediate Agent
PPP E I
O NTERMEDIATE
pppoe
intermediate-agent
A
GENT
This section describes commands used to configure the PPPoE Intermediate
Agent (PPPoE IA) relay parameters required for passing authentication
messages between a client and broadband remote access servers.

Table 83: PPPoE Intermediate Agent Commands

Command Function
pppoe Enables the PPPoE IA globally on the switch
intermediate-agent
pppoe Sets the access node identifier and generic error
intermediate-agent message for the switch
format-type
pppoe Enables the PPPoE IA on an interface
intermediate-agent
port-enable
pppoe Sets the circuit-id or remote-id for an interface
intermediate-agent
port-format-type
pppoe Sets the trust mode for an interface
intermediate-agent trust
pppoe Enables the stripping of vendor tags from PPPoE
intermediate-agent Discovery packets sent from a PPPoE server
vendor-tag strip
clear pppoe Clears PPPoE IA statistics
intermediate-agent
statistics
show pppoe Displays PPPoE IA configuration settings
intermediate-agent info
show pppoe Displays PPPoE IA statistics
intermediate-agent
statistics
This command enables the PPPoE Intermediate Agent globally on the
switch. Use the no form to disable this feature.
S
YNTAX
[no] pppoe intermediate-agent
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The switch inserts a tag identifying itself as a PPPoE Intermediate Agent
◆
residing between the attached client requesting network access and the
ports connected to broadband remote access servers (BRAS). The
switch extracts access-loop information from the client's PPPoE Active
Discovery Request, and forwards this information to all trusted ports
– 858 –
Mode
GC
GC
IC
IC
IC
IC
PE
PE
PE