Configuring Mvr Global Settings - Edge-Core ECS3510-28T Management Manual

Figure 383: MVR Concept
Satellite Services
C
OMMAND
General Configuration Guidelines for MVR:
◆
1.
2.
3.
4.
Although MVR operates on the underlying mechanism of IGMP
◆
snooping, the two features operate independently of each other. One
can be enabled or disabled without affecting the behavior of the other.
However, if IGMP snooping and MVR are both enabled, MVR reacts only
to join and leave messages from multicast groups configured under
MVR. Join and leave messages from all other multicast groups are
managed by IGMP snooping. Also, note that only IGMP version 2 or 3
hosts can issue multicast join or leave messages.
Use the Multicast > MVR (Configure Global) page to configure proxy
C
ONFIGURING
switching and the robustness variable.
MVR G
LOBAL
S
ETTINGS
CLI R
EFERENCES
◆ "MVR for IPv4" on page 1246
Multicast Server
U
SAGE
Enable MVR for a domain on the switch, and select the MVR VLAN
(see "Configuring MVR Domain Settings" on page
Create an MVR profile by specifying the multicast groups that will
stream traffic to attached hosts, and assign the profile to an MVR
domain (see "Configuring MVR Group Address Profiles" on
page 645).
Set the interfaces that will join the MVR as source ports or receiver
ports (see "Configuring MVR Interface Status" on page
For multicast streams that will run for a long term and be associated
with a stable set of hosts, you can statically bind the multicast
group to the participating interfaces (see
Multicast Groups to Interfaces" on page
– 641 –
| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration for IPv4
Multicast Router
Layer 2 Switch
Receiver
Ports
Set-top Box
TV
PC
644).
"Assigning Static MVR
650).
Service
Network
Source
Port
Set-top Box
TV
648).