Filtering Igmp Query Packets And Multicast Data - Edge-Core ECS3510-28T Management Manual

F IGMP
ILTERING
Q P
UERY ACKETS AND
M D
ULTICAST ATA
To show the interface settings for IGMP snooping:
Click Multicast, IGMP Snooping, Interface.
1.
Select Show VLAN Information from the Action list.
2.
Figure 362: Showing Interface Settings for IGMP Snooping
Use the Multicast > IGMP Snooping > Interface (Configure Interface) page
to configure an interface to drop IGMP query packets or multicast data
packets.
CLI R
EFERENCES
"ip igmp query-drop" on page 1222
◆
"ip multicast-data-drop" on page 1222
◆
P
ARAMETERS
These parameters are displayed:
Interface – Specifies port or trunk selection.
◆
IGMP Query Drop – Configures an interface to drop any IGMP query
◆
packets received on the specified interface. If this switch is acting as a
Querier, this prevents it from being affected by messages received from
another Querier. (Default: Disabled)
Multicast Data Drop – Configures an interface to stop multicast
◆
services from being forwarded to users attached to the downstream
port; i.e., the interfaces specified by this command. (Default: Disabled)
W I
EB NTERFACE
To drop IGMP query packets or multicast data packets:
Click Multicast, IGMP Snooping, Interface.
1.
Select Configure Port or Configure Trunk from the Action List.
2.
Enable the required drop functions for any interface.
3.
Click Apply.
4.
– 621 –
| Multicast Filtering
C 17
HAPTER
Layer 2 IGMP (Snooping and Query for IPv4)