Edge-Core ECS3510-28T Management Manual page 1068

| Spanning Tree Commands
C 33
HAPTER
name
revision
which cover the same general area of your network. However,
remember that you must configure all bridges within the same MSTI
Region (page 1068) with the same set of instances, and the same
instance (on each bridge) with the same set of VLANs. Also, note that
RSTP treats each MSTI region as a single node, connecting all regions
to the Common Spanning Tree.
E
XAMPLE
Console(config-mstp)#mst 1 vlan 2-5
Console(config-mstp)#
This command configures the name for the multiple spanning tree region in
which this switch is located. Use the no form to clear the name.
S
YNTAX
name name
name - Name of the spanning tree.
D S
EFAULT ETTING
Switch's MAC address
C M
OMMAND ODE
MST Configuration
C U
OMMAND SAGE
The MST region name and revision number
designate a unique MST region. A bridge (i.e., spanning-tree compliant
device such as this switch) can only belong to one MST region. And all
bridges in the same region must be configured with the same MST
instances.
E
XAMPLE
Console(config-mstp)#name R&D
Console(config-mstp)#
R C
ELATED OMMANDS
revision (1068)
This command configures the revision number for this multiple spanning
tree configuration of this switch. Use the no form to restore the default.
S
YNTAX
revision number
number - Revision number of the spanning tree. (Range: 0-65535)
– 1068 –
(page 1068) are used to