Table 76: Web Server Commands - Edge-Core ECS3510-28T Management Manual

W S
EB ERVER
ip http port
Interface : Eth 1/1
Method List : tps
Group List : radius
Interface : Eth 1/2
Accounting Type : EXEC
Method List : default
Group List : tacacs+
Interface : vty
Console#
This section describes commands used to configure web browser
management access to the switch.

Table 76: Web Server Commands

Command Function
ip http port Specifies the port to be used by the web browser
interface
ip http server Allows the switch to be monitored or configured from
a browser
ip http secure-port Specifies the UDP port number for HTTPS
ip http secure-server Enables HTTPS (HTTP/SSL) for encrypted
communications
Note: Users are automatically logged off of the HTTP server or HTTPS
server if no input is detected for 300 seconds.
This command specifies the TCP port number used by the web browser
interface. Use the no form to use the default port.
S
YNTAX
ip http port port-number
no ip http port
port-number - The TCP port to be used by the browser interface.
(Range: 1-65535)
D S
EFAULT ETTING
80
C M
OMMAND ODE
Global Configuration
– 825 –
| Authentication Commands
C 23
HAPTER
Web Server
Mode
GC
GC
GC
GC