Show Snmp-Server Enable Port-Traps; Snmpv3 Commands; Snmp-Server Engine-Id - Edge-Core ECS3510-28T Management Manual

| SNMP Commands
C 21
HAPTER

SNMPv3 Commands

show snmp-server
enable port-traps
SNMPv3 Commands
snmp-server
engine-id
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps mac-notification
Console(config)#
This command shows if SNMP traps are enabled or disabled for the
specified interfaces.
S
YNTAX
show snmp-server enable port-traps interface [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
Console#show snmp-server enable port-traps interface
Interface MAC Notification Trap
--------- ---------------------
Eth 1/1
Eth 1/2
Eth 1/3
. .
.
This command configures an identification string for the SNMPv3 engine.
Use the no form to restore the default.
S
YNTAX
snmp-server engine-id {local | remote {ip-address}}
engineid-string
no snmp-server engine-id {local | remote {ip-address}}
local - Specifies the SNMP engine on this switch.
remote - Specifies an SNMP engine on a remote device.
ip-address - IPv4 or IPv6 address of the remote device.
engineid-string - String identifying the engine ID. (Range: 1-26
hexadecimal characters)
– 780 –
No
No
No