Edge-Core ECS3510-28T Management Manual page 968

| Interface Commands
C 26
HAPTER
Interface Configuration
Interface Configuration
interface
Table 106: Interface Commands (Continued)
Command Function
transceiver-threshold Sets thresholds for the transceiver temperature which
temperature can be used to trigger an alarm or warning message
transceiver-threshold Sets thresholds for the transceiver power level of the
tx-power transmitted signal which can be used to trigger an
alarm or warning message
transceiver-threshold Sets thresholds for the transceiver voltage which can
voltage be used to trigger an alarm or warning message
show interfaces Displays the temperature, voltage, bias current,
transceiver transmit power, and receive power
show interfaces Displays the alarm/warning thresholds for
transceiver-threshold temperature, voltage, bias current, transmit power,
and receive power
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port
show cable-diagnostics Shows the results of a cable diagnostics test
Power Savings
power-save Enables power savings mode on the specified port
show power-save Shows the configuration settings for power savings
This command configures an interface type and enters interface
configuration mode. Use the no form with a trunk to remove an inactive
interface.
S
YNTAX
[no] interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
vlan vlan-id (Range: 1-4094)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
– 968 –
Mode
IC
IC
IC
PE
PE
PE
PE
IC
PE