Table 98: Commands For Configuring Traffic Segmentation - Edge-Core ECS3510-28T Management Manual

| General Security Measures
C 24
HAPTER
Port-based Traffic Segmentation
P - T
ORT BASED RAFFIC
traffic-segmentation
WinNuke Attack : Disabled, 1000 kilobits per second
Console#
S
EGMENTATION
If tighter security is required for passing traffic from different clients
through downlink ports on the local network and over uplink ports to the
service provider, port-based traffic segmentation can be used to isolate
traffic for individual clients.
Traffic belonging to each client is isolated to the allocated downlink ports.
But the switch can be configured to either isolate traffic passing across a
client's allocated uplink ports from the uplink ports assigned to other
clients, or to forward traffic through the uplink ports used by other clients,
allowing different clients to share access to their uplink ports where
security is less likely to be compromised.

Table 98: Commands for Configuring Traffic Segmentation

Command
traffic-segmentation
traffic-segmentation session
traffic-segmentation uplink/
downlink
traffic-segmentation
uplink-to-uplink
show traffic-segmentation
This command enables traffic segmentation. Use the no form to disable
traffic segmentation.
S
YNTAX
[no] traffic-segmentation
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Traffic segmentation provides port-based security and isolation
◆
between ports within the VLAN. Data traffic on the downlink ports can
only be forwarded to, and from, the designated uplink port(s). Data
cannot pass between downlink ports in the same segmented group, nor
to ports which do not belong to the same group.
– 938 –
Function
Enables traffic segmentation
Creates a client session
Configures uplink/downlink ports for client sessions
Specifies whether or not traffic can be forwarded
between uplink ports assigned to different client
sessions
Displays the configured traffic segments
Mode
GC
GC
GC
GC
PE