Configuring Global Settings For Web Authentication - Edge-Core ECS3510-28T Management Manual

C G
ONFIGURING LOBAL
S W
ETTINGS FOR EB
A
UTHENTICATION
RADIUS authentication must be activated and configured properly
N :
OTE
for the web authentication feature to work properly. (See
Local/Remote Logon Authentication" on page
Web authentication cannot be configured on trunk ports.
N :
OTE
Use the Security > Web Authentication (Configure Global) page to edit the
global parameters for web authentication.
CLI R
EFERENCES
"Web Authentication" on page 885
◆
P
ARAMETERS
These parameters are displayed:
Web Authentication Status – Enables web authentication for the
◆
switch. (Default: Disabled)
Note that this feature must also be enabled for any port where required
under the Configure Interface menu.
Session Timeout – Configures how long an authenticated session
◆
stays active before it must re-authenticate itself. (Range: 300-3600
seconds; Default: 3600 seconds)
Quiet Period – Configures how long a host must wait to attempt
◆
authentication again after it has exceeded the maximum allowable
failed login attempts. (Range: 1-180 seconds; Default: 60 seconds)
Login Attempts – Configures the amount of times a supplicant may
◆
attempt and fail authentication before it must wait the configured quiet
period. (Range: 1-3 attempts; Default: 3 attempts)
W I
EB NTERFACE
To configure global parameters for web authentication:
Click Security, Web Authentication.
1.
Select Configure Global from the Step list.
2.
Enable web authentication globally on the switch, and adjust any of the
3.
protocol parameters as required.
Click Apply.
4.
– 325 –
| Security Measures
C 13
HAPTER
Web Authentication
"Configuring
307.)