Configuring A Standard Ipv6 Acl - Edge-Core ECS3510-28T Management Manual

C
ONFIGURING A
S IP 6 ACL
TANDARD V
Figure 193: Configuring an Extended IPv4 ACL
Use the Security > ACL (Configure ACL - Add Rule - IPv6 Standard) page to
configure a Standard IPv6ACL.
CLI R
EFERENCES
"permit, deny (Standard IPv6 ACL)" on page 951
◆
"show ipv6 access-list" on page 955
◆
◆ "Time Range" on page 762
P
ARAMETERS
These parameters are displayed in the web interface:
Type – Selects the type of ACLs to show in the Name list.
◆
Name – Shows the names of ACLs matching the selected type.
◆
◆ Action – An ACL can contain any combination of permit or deny rules.
Source Address Type – Specifies the source IP address. Use "Any" to
◆
include all possible addresses, "Host" to specify a specific host address
in the Address field, or "IPv6-Prefix" to specify a range of addresses.
(Options: Any, Host, IPv6-Prefix; Default: Any)
Source IPv6 Address – An IPv6 source address or network class. The
◆
address must be formatted according to RFC 2373 "IPv6 Addressing
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields.
Source Prefix-Length – A decimal value indicating how many
◆
contiguous bits (from the left) of the address comprise the prefix (i.e.,
the network portion of the address). (Range: 0-128 bits)
– 359 –
| Security Measures
C 13
HAPTER
Access Control Lists