Displaying Fault Notification Settings - Edge-Core ECS3510-28T Management Manual

| Basic Administration Protocols
C 14
HAPTER
Connectivity Fault Management
D F
ISPLAYING AULT
N
OTIFICATION
S
ETTINGS
EgrVid – The Egress Port can be identified, but the bridge port is not
■
in the LTM's VID member set, and was therefore filtered by egress
filtering.
Reply – Reply action:
◆
FDB – Target address found in forwarding database.
■
MPDB – Target address found in the maintenance point database.
■
HIT – Target located on this device.
■
W I
EB NTERFACE
To show information about link trace operations launched from this device:
Click Administration, CFM.
1.
Select Show Information from the Step list.
2.
Select Show Link Trace Cache from the Action list.
3.
Figure 313: Showing the Link Trace Cache
Use the Administration > CFM > Show Information (Show Fault Notification
Generator) page to display configuration settings for the fault notification
generator.
CLI R
EFERENCES
"show ethernet cfm fault-notify-generator" on page 1349
◆
P
ARAMETERS
These parameters are displayed:
MEP ID – Maintenance end point identifier.
◆
MD Name – Maintenance domain name.
◆
MA Name – Maintenance association name.
◆
Highest Defect – The highest defect that will generate a fault alarm.
◆
(This is disabled by default.)
Lowest Alarm – The lowest defect that will generate a fault alarm
◆
– 546 –
.
12