Edge-Core ECS3510-28T Management Manual page 1020

| Congestion Control Commands
C 29
HAPTER
Rate Limit Commands
rate-limit
This command defines the rate limit for a specific interface. Use this
command without specifying a rate to restore the default rate. Use the no
form to restore the default status of disabled.
S
YNTAX
rate-limit {input | output} [rate]
no rate-limit {input | output}
input – Input rate for specified interface
output – Output rate for specified interface
rate – Maximum value in Kbps.
(Range: 64-100000 Kbps for Fast Ethernet ports,
64-1000000 Kbps for Gigabit Ethernet ports)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
Using both rate limiting and storm control on the same interface may lead
to unexpected results. It is therefore not advisable to use both of these
commands on the same interface.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 64
Console(config-if)#
R C
ELATED OMMAND
show interfaces switchport (980)
– 1020 –