Edge-Core ECS3510-28T Management Manual page 691

C U
OMMAND SAGE
◆ This command resets the entire system.
Any combination of reload options may be specified. If the same option
◆
is re-specified, the previous setting will be overwritten.
◆ When the system is restarted, it will always run the Power-On Self-Test.
It will also retain all configuration information stored in non-volatile
memory by the
"copy" on page
E
XAMPLE
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January
***
Are you sure to reboot the system at the specified time? <y/n>
This command activates Privileged Exec mode. In privileged mode,
enable
additional commands are available, and certain commands display
additional information. See
page 682.
S
YNTAX
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
D S
EFAULT ETTING
Level 15
C M
OMMAND ODE
Normal Exec
C U
OMMAND SAGE
◆ "super" is the default password required to change the command mode
from Normal Exec to Privileged Exec. (To set this password, see the
enable password
The "#" character is appended to the end of the prompt to indicate that
◆
the system is in privileged access mode.
C
copy running-config startup-config
718).
1 02:10:43 2007 ---
"Understanding Command Modes" on
command.)
– 691 –
| General Commands
19
HAPTER
command (See