Edge-Core ECS3510-28T Management Manual page 1048

| Loopback Detection Commands
C 31
HAPTER
loopback-detection
transmit-interval
loopback detection
trap
E
XAMPLE
Console(config)#loopback-detection recover-time 120
Console(config-if)#
This command specifies the interval at which to transmit loopback
detection control frames. Use the no form to restore the default setting.
S
YNTAX
loopback-detection transmit-interval seconds
no loopback-detection transmit-interval
seconds - The transmission interval for loopback detection control
frames. (Range: 1-32767 seconds)
D S
EFAULT ETTING
10 seconds
C M
OMMAND ODE
Global Configuration
E
XAMPLE
Console(config)#loopback-detection transmit-interval 60
Console(config)#
This command sends a trap when a loopback condition is detected, or when
the switch recovers from a loopback condition. Use the no form to restore
the default state.
S
YNTAX
loopback-detection trap [both | detect | none | recover]
no loopback-detection trap
both - Sends an SNMP trap message when a loopback condition is
detected, or when the switch recovers from a loopback condition.
detect - Sends an SNMP trap message when a loopback condition is
detected.
none - Does not send an SNMP trap for loopback detection or
recovery.
recover - Sends an SNMP trap message when the switch recovers
from a loopback condition.
D S
EFAULT ETTING
None
– 1048 –