Sending Simple Mail Transfer Protocol Alerts - Edge-Core ECS3510-28T Management Manual

S S M
ENDING IMPLE AIL
T P
RANSFER ROTOCOL
A
LERTS
3 is specified, all messages from level 0 to level 3 will be sent to the
remote server. (Range: 0-7, Default: 7)
Server IP Address – Specifies the IPv4 or IPv6 address of a remote
◆
server which will be sent syslog messages.
UDP Port – Specifies the UDP port number used by the remote server.
◆
(Range: 1-65535; Default: 514)
W I
EB NTERFACE
To configure the logging of error messages to remote servers:
Click Administration, Log, Remote.
1.
Enable remote logging, specify the facility type to use for the syslog
2.
messages. and enter the IP address of the remote servers.
Click Apply.
3.
Figure 231: Configuring Settings for Remote Logging of Error Messages
Use the Administration > Log > SMTP page to alert system administrators
of problems by sending SMTP (Simple Mail Transfer Protocol) email
messages when triggered by logging events of a specified level. The
messages are sent to specified SMTP servers on the network and can be
retrieved using POP or IMAP clients.
CLI R
EFERENCES
◆ "SMTP Alerts" on page 745
P
ARAMETERS
These parameters are displayed:
SMTP Status – Enables/disables the SMTP function. (Default: Enabled)
◆
Severity – Sets the syslog severity threshold level (see table on
◆
page 418) used to trigger alert messages. All events at this level or
– 421 –
| Basic Administration Protocols
C 14
HAPTER
Configuring Event Logging