Assigning Static Mvr6 Multicast Groups To Interfaces - Edge-Core ECS3510-28T Management Manual

| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration for IPv6
A S
SSIGNING TATIC
MVR6 M
ULTICAST
G
ROUPS TO
I
NTERFACES
W I
EB NTERFACE
To configure interface settings for MVR6:
Click Multicast, MVR6.
1.
Select Configure Interface from the Step list.
2.
Select Port or Trunk interface.
3.
Select an MVR6 domain.
4.
Set each port that will participate in the MVR6 protocol as a source port
5.
or receiver port, and optionally enable Immediate Leave on any
receiver port to which only one subscriber is attached.
Click Apply.
6.
Figure 403: Configuring Interface Settings for MVR6
Use the Multicast > MVR6 (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI R
EFERENCES
"mvr6 vlan group" on page 1278
◆
C U
OMMAND SAGE
Multicast groups can be statically assigned to a receiver port using this
◆
configuration page.
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
◆
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
The MVR6 VLAN cannot be specified as the receiver VLAN for static
◆
bindings.
– 666 –