Setting An Ip Address - Edge-Core ECS3510-28T Management Manual

Username: admin
Password:
CLI session with the ECS3510-28T* is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#
* This manual covers the ECS3510-28T and ECS3510-52T switches. Other
than the difference in the number of ports, there are no significant
differences. Therefore nearly all of the screen display examples are
based on the ECS3510-28T.
You must establish IP address information for the switch to obtain
S IP
ETTING AN
management access through the network. This can be done in either of the
A
DDRESS
following ways:
Manual — You have to input the information, including IP address and
◆
subnet mask. If your management station is not in the same IP subnet
as the switch, you will also need to specify the default gateway router.
Dynamic — The switch can send IPv4 configuration requests to BOOTP
◆
or DHCP address allocation servers on the network, or can
automatically generate a unique IPv6 host address based on the local
subnet address prefix received in router advertisement messages. An
IPv6 link local address for use in a local network can also be
dynamically generated as described in
page
DHCP for IPv6 can be used to acquire stateful address configuration
information depending on the advertisements received from other
routers, and subsequently from a DHCPv6 server. (For more
information, see the description for the "Restart DHCPv6" parameter
under
M
ANUAL
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and
management stations that exist on another network segment. Valid IPv4
addresses consist of four decimal numbers, 0 to 255, separated by periods.
Anything outside this format will not be accepted by the CLI program.
N :
OTE
88.
"Configuring IPv6 Interface Settings" on page
C
ONFIGURATION
The IPv4 address for VLAN 1 is obtained via DHCP by default.
– 83 –
| Initial Switch Configuration
C 2
HAPTER
Basic Configuration
"Obtaining an IPv6 Address" on
569.)