Table of Contents
Advertisement
Step 1542-9
1. Boot standalone diagnostics from CD-ROM.
2. If the Please Define the System Console prompt is displayed, follow directions to select the system
console.
3. Use the Display Configuration and Resource List to list all attached devices and adapters (refer to the
RS/6000 Eserver pSeries Diagnostic Information for Multiple Bus Systems, if necessary).
4. Check that all attached devices and adapters are listed.
Is the Please Define the System Console prompt displayed and are all attached devices and
adapters listed?
NO
Go to "Step 1542-13" on page 76.
YES
Go to "Step 1542-6" on page 74.
Step 1542-10
1. If it is not already off, turn off the power.
2. Remove all adapters from slots 1, 2, 3, 4, 5, and 6 (location codes U0.1-P1-I1 through I6) in the
system that are not attached to the boot device.
3. Label and record the location of any cables attached to the adapters.
4. Record the slot number of the adapters.
5. Turn on the power to boot standalone diagnostics from the CD-ROM.
6. If the ASCII terminal panel displays Enter 0 to select this console, press 0 on the ASCII terminal
keyboard.
7. If the Please Define the System Console prompt is displayed, follow directions to select the system
console.
8. Use the Display Configuration and Resource List to list all attached devices and adapters (refer to the
RS/6000 Eserver pSeries Diagnostic Information for Multiple Bus Systems, if necessary).
9. Check that all attached devices and adapters are listed.
Is the Please Define the System Console prompt displayed and are all attached devices and
adapters listed?
NO
Go to "Step 1542-8" on page 74.
YES
Go to "Step 1542-11".
Step 1542-11
If the Please Define the System Console prompt is displayed and all attached devices and adapters are
listed, the problem is with one of the adapter cards or devices that was removed or disconnected from the
I/O subsystem.
1. Turn off the power.
2. Reinstall the adapter or device that was removed. Use the original adapter cards in their original slots
when reinstalling adapters.
3. Turn on the power to boot standalone diagnostics from CD-ROM.
4. If the Please Define the System Console prompt is displayed, follow directions to select the system
console.
5. Use the Display Configuration and Resource List to list all attached devices and adapters (refer to the
RS/6000 Eserver pSeries Diagnostic Information for Multiple Bus Systems, if necessary).
6. Check that all attached devices and adapters are listed.
Chapter 3. Maintenance Analysis Procedures (MAPs)
75
Advertisement
Table of Contents
