Table of Contents
Advertisement
4. Remove the retaining screws that secure the latch bracket to the side of the NAS Gateway 500.
6
7
1
1 System drawer-release latch
2 System drawer-release latch bracket (right)
3 NAS Gateway 500
4 System drawer-release latch bracket (left)
Drawer-release latch bracket replacement
To replace the NAS Gateway 500 drawer-release latch brackets, do the following:
1. If you have not already done so, open the front rack door and place the system into the service
position as described in "Placing the NAS Gateway 500 into the service position" on page 312.
2. Using the supplied retaining screws, secure the latch brackets to the side of the NAS Gateway 500.
Note: The latch brackets are right-side and left-side dependent.
3. Replace the release latch as described in "Drawer-release latch replacement" on page 321.
4. Replace the front bezel as described in "Front bezel replacement" on page 315.
5. Push the system drawer back into the operating position as described in "Returning the NAS Gateway
500 to the operating position" on page 313.
322
NAS Gateway 500 Service Guide
2
8
3
4
6
5
7
8
5 System drawer-release latch
6 Retaining screws
7 Release latch retaining screw
8 Latch bracket post
Advertisement
Table of Contents
