Table of Contents
Advertisement
OS Surveillance Setup Menu
1. Surveillance:
Currently Enabled
2. Surveillance Time Interval:
2 minutes
3. Surveillance Delay:
2 minutes
98. Return to Previous Menu
0>
– Surveillance
Can be set to Enabled or Disabled.
– Surveillance Time Interval
Can be set to any number from 2 through 255.
– Surveillance Delay
Can be set to any number from 0 through 255.
Refer to "Service processor system monitoring - surveillance" on page 287 for more information about
surveillance.
v Reset Service Processor
If this option is selected, entering Y causes the service processor to reboot.
v Reprogram Flash EPROM Menu
This option requires a diskette drive to be installed in the system. If this option is selected, and no
diskette drive is present in the system, the service processor will display "Not Supported."
This option updates the system EPROMs. After entering Y to indicate that you want to continue, you are
prompted to enter the update diskettes. Follow the instructions on the console. When the update is
complete, the service processor reboots.
All system EPROMs that can be reprogrammed are updated at the same time and are as follows:
– System-power-control network programming
– Service processor programming
– System firmware programming
– Run-Time Abstraction Services
v Serial Port Snoop Setup Menu
This menu can be used to set up serial port snooping, in which the user can configure serial port 1 as a
"catch-all" reset device.
From the service processor main menu, select option 1, service processor setup menu, and then select
option 8 (Serial Port Snoop Setup Menu).
Chapter 9. Using the service processor
261
Advertisement
Table of Contents
