Table of Contents
Advertisement
13. Turn the locking latch and lift the plastic retainer seat off the adapter.
1 System unit
2 Adapter retainer assembly
3 Adapter retainer assembly (retainer seat down and the retainer clip in the locked position)
4 Adapter retainer assembly (retainer seat down and the retainer clip in the unlocked position)
5 PCI-X adapter faceplate (dotted lines)
6 Adapter retainer assembly (in the unlocked position)
7 PCI-X adapter
14. Carefully grasp the adapter by the edges, pull it straight out from the PCI riser card, and place in a
safe place.
15. If necessary, remove the adapter from the antistatic package and place the adapter, component-side
up, on a flat, static-protective surface.
Attention:
Avoid touching the components and gold-edge connectors on the adapter.
16. Verify jumper settings. See "Verifying jumpers on PCI-X adapter options" on page 332.
17. To install the adapter in the adapter slot, carefully grasp the adapter by the edges and align the
adapter in the slot guides. Insert the adapter fully into the adapter slot connector. If you are installing
a full-length adapter, ensure that both ends of the adapter engage the card guides.
326
NAS Gateway 500 Service Guide
6
2
1
7
3
4
5
Advertisement
Table of Contents
