IBM TotalStorage NAS Gateway 500 Service Manual page 135

Table 10. Firmware checkpoints (continued)
Checkpoint
E57F
E580
E581
E582
E583
E584
E585
E586
E587
Description
End of RIO interface chip initialization
Begin initializing the EADS module.
Read the PCI bus configuration header.
EADS has been detected.
Running BIST on the current EADS
Checking function of current EADS
Valid function of current EADS detected
Set up EADS function
Set up EADS BIST
Action or
possible failing FRU
1. Check for system firmware updates.
2. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
1. Check for system firmware updates.
2. Replace the I/O subsystem backplane
specified by the location code.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
Chapter 4. Checkpoints
115