Table of Contents
Advertisement
10. Remove the PCI-X adapters as described in "PCI-X adapter removal" on page 328.
14
1 Service access cover (drawer)
2 Primary and redundant PCI cooling fans
3 PCI cooling fan and stabilizing bracket
4 Processor cooling fans
5 Processor cooling fan cage
6 PCI riser card
7 PCI-X adapters
8 CEC backplane
9 NAS Gateway 500 chassis
10 Diskette drive
11. Remove the media drives as described in "Media drive removal" on page 337.
12. Remove all processor books or the processor filler panel as described in "Processor book removal"
on page 343.
13. Remove all power supplies as described in "Power supply removal" on page 351.
14. Remove the PCI riser card as described in "PCI riser card removal" on page 354.
15. Remove the PCI cooling fans as described in "Fan assembly removal" on page 334.
16. Remove cables from clamps attached to PCI cooling fan stabilizing bracket.
17. Remove the PCI cooling fan's stabilizing bracket.
Note: The bracket is secured to the CEC backplane with four hex-head screws and two alignment
tabs.
18. Remove and label all remaining power, signal, and SCSI cables.
1
18
17
15
13
12
11
2
3
6
16
8
10
11 Front bezel
12 IDE CD-ROM drive
13 Operator panel
14 Front power supply and processor support bracket
15 Media device support shelf
16 Processor assemblies 1 and 2
16a Processor filler panel
17 Power supplies 1 and 2
18 Plastic membrane
Chapter 11. Removal and replacement procedures
4
5
7
9
16a
367
Advertisement
Table of Contents
