Table of Contents
Advertisement
18. Disconnect all power and signal cables connected to the disk drive backplane.
19. Remove the four retaining screws that secure the disk drive cage to the front of the system chassis.
20. Remove the two screws, located by the backplane card, that secure the disk drive cage to the
chassis bottom.
21. Remove the two screws on the outside of the chassis that secure the disk drive cage to the chassis.
These are on the right side towards the front.
22. Slide the disk drive cage back until it clears the upper chassis ledge.
23. Pull the disk-drive-cage assembly out of the system.
24. Remove the six retaining thread-lock screws attached to the disk drive backplane.
Note: These six screws have thread-lock on them. Keep them separate from the chassis screws.
1 Service access cover (drawer)
2 PCI-X adapters
3 PCI riser card
4 PCI cooling fan
5 Stabilizing cage
6 PCI cooling fan
7 Disk drive backplane
8 Disk drive cage
360
NAS Gateway 500 Service Guide
16
1
6
15
14
13
11
12
4
5
7
8
10
9 NAS Gateway 500 Chassis
10 Disk drive (2 out of 4 pack)
11 Media device
12 Front bezel
13 IDE CD-ROM media
14 Media-device-support shelf
15 Processor assembly #2
16 Processor filler
2
3
9
Advertisement
Table of Contents
