Table of Contents
Advertisement
4. Turn on the power.
5. If the Console Selection panel is displayed, choose the system console.
6. After the word keyboard is displayed, press 5 on the ASCII terminal keyboard.
7. If you are prompted to do so, enter the appropriate password.
Is the Please Define the System Console prompt displayed?
NO
The last device or cable that you attached is defective.
To test each FRU, exchange the FRUs in the following order:
1. Device and cable (last one attached)
2. CEC backplane (see notes on page 39)
If the symptom did not change and all the FRUs have been exchanged, call service support for
assistance.
If the symptom has changed, check for loose cards, cables, and obvious problems. If you do not
find a problem, go to the "Quick Entry MAP" on page 40 and follow the instructions for the new
symptom.
Go to "MAP 0410: Repair Checkout" on page 45.
YES
Repeat this step until all of the devices are attached.
Go to "Step 1548-15".
Step 1548-15
The system is working correctly with this configuration. One of the adapters that you removed might be
defective.
1. Turn off the power and remove the power cords.
2. Install an adapter and connect any cables and devices that were attached to the FRU.
3. Plug in the power cords and wait for the operator panel to display OK.
4. Turn on the power.
5. If the Console Selection panel is displayed, choose the system console.
6. After the word keyboard is displayed, press 5 on the ASCII terminal keyboard.
7. If you are prompted to do so, enter the appropriate password.
Is the Please Define the System Console prompt displayed?
NO
Go to "Step 1548-16".
YES
Repeat this step until all of the adapters are installed.
Go to "MAP 0410: Repair Checkout" on page 45.
Step 1548-16
The last adapter installed or one of its attached devices is probably defective.
1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive.
2. Turn off the power and remove the power cords.
3. Starting with the last installed adapter, disconnect one attached device and cable.
4. Plug in the power cords and wait for the OK prompt to display on the operator panel.
5. Turn on the power.
6. If the Console Selection panel is displayed, choose the system console.
7. After the word keyboard is displayed, press the number 5 key on the ASCII terminal keyboard.
8. Enter the appropriate password if you are prompted to do so.
Chapter 3. Maintenance Analysis Procedures (MAPs)
85
Advertisement
Table of Contents
