Table of Contents
Advertisement
Option 2 displays the following:
Scan Log Dump Setup Menu
1. Scan Log Dump Policy:
Currently As Needed
2. Scan Log Dump Content:
Currently As Requested
3. Immediate Dump
98. Return to Previous Menu
0> 2
Select from the following options:
(As Requested=1, Optimum=2, Complete=3, Minimum=4)
Enter New Option:
0>
The scan-log-dump content can be set to the following:
1 = As Requested
The processor run-time diagnostics will select the contents of the dump file based on the type of
error that occurs. This is the default.
2 = Optimum
The dump will include the smallest amount of information to diagnose a hardware error.
3 = Complete
The dump will include as much information as possible to allow the complete analysis of hardware
and software errors.
4 = Minimum
The dump will include the smallest amount of information possible (a minimum number of
hardware scan log rings).
The complete dump will take the longest time to finish; it may take as long as 1.5 hours on a fully
configured system.
Option 3, Immediate Dump, can be used only when the system is in the standby state with power on. It is
used to dump the system data after a checkstop or machine check occurs when the system firmware is
running, or when the operating system is booting or running.
The scan-log-dump policy can also be set from the Tasks menu in the diagnostic service aids.
If a valid dump file already exists, the dump control code will stop because the contents of the prior dump
must be protected.
264
NAS Gateway 500 Service Guide
Advertisement
Table of Contents
