Table of Contents
Advertisement
12. Gently insert the new battery into its plastic mount.
13. Replace processor book 1 as described in "Processor book insertion" on page 344.
14. Replace the media device support shelf. Tighten the thumbscrew located on the support shelf.
Note: When replacing the support shelf, ensure that the lower support leg activates the microswitch
located on the CEC backplane. Failure to do so results in the system not being able to power
on.
15. Replace all media drives, ensuring that the media drives removed are returned to the same media
bay from which they were removed as described in "Media drive replacement" on page 338.
16. Reconnect all power and signal cables to their respective media drives.
17. Replace the front bezel as described in "Front bezel replacement" on page 315.
18. Replace the service access cover, as described in "Service access cover replacement" on page 314.
19. Push the system drawer back into the operating position as described in "Returning the NAS
Gateway 500 to the operating position" on page 313.
20. Turn on the system power.
21. The bootlist command might need to be run while logged in as root user. This action rebuilds the
customized boot list. Internet protocol (IP) parameters might also need to be reentered.
350
NAS Gateway 500 Service Guide
Advertisement
Table of Contents
