Table of Contents
Advertisement
Table 10. Firmware checkpoints (continued)
Checkpoint
E5E3
E5E4
E5E5
E5E6
E5E7
E5E8
E5E9
E5EE
E5EF
E5FE
E600
E601
118
NAS Gateway 500 Service Guide
Description
Not in quick-restart: load and set up open
firmware code in memory
Activate slave processors
Initialize the hypervisor, phase 2
Set L2 and processor status
Save I/O hub information for RTAS and
open firmware
Set up registers
Reset the quick restart path
Hang state in main control code
End of low-level firmware
Get the system's licensed memory quantity
from the service processor
SSA PCI adapter open firmware has run
successfully.
SSA PCI adapter BIST has started but
failed to complete after 4 seconds.
Action or
possible failing FRU
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Check for system firmware updates.
2. Go to "MAP 1548: Processor
Subsystem Problem Isolation" on
page 77.
1. Remove, then reapply AC power to the
system using the UEPO switch.
2. Verify that the CUoD capacity card is
installed and properly seated.
3. Call service support.
Replace the adapter.
Replace the adapter.
Advertisement
Table of Contents
