IBM TotalStorage NAS Gateway 500 Service Manual page 350

6. Rotate the locking retainer clip on the identified slot, lift the plastic stop, and remove the expansion
slot cover.
1 System unit
2 Adapter retainer assembly
3 Adapter retainer assembly (retainer seat
down and the retainer clip in the locked
position)
4 Adapter retainer assembly (retainer seat
down and the retainer clip in the unlocked
position)
7. When you are instructed to install the adapter in the adapter slot, carefully grasp the adapter by the
edges and align the adapter in the slot guides. Insert the adapter fully into the adapter slot connector.
If you are installing a full-length adapter, ensure that both ends of the adapter engage the card
guides.
330
NAS Gateway 500 Service Guide
6
2
1
5 PCI-X adapter faceplate (dotted lines)
6 Adapter retainer assembly (in the unlocked position)
7 PCI-X adapter
7
3
4
5