IBM TotalStorage NAS Gateway 500 Service Manual page 153

Hide thumbs Also See for TotalStorage NAS Gateway 500:
Table of Contents

Advertisement

Table 13. SPCN error codes for the CEC (system unit) (continued)
Error code Description
1011 8409 No valid processor card VPD found.
1011 840A VPD +5 stuck high
1011 840B VPD +5 stuck low
1011 840C DIMM misplugged.
1011 840D SPCN configuration
1011 840E SPCN default configuration loaded.
1011 840F I/O type not recognized.
1011 8413 Invalid processor 1 VPD
1011 8414 Invalid processor 2 VPD
1011 8423 No processor 1 VPD
1011 8424 No processor 2 VPD
Action or
possible failing FRU
1. Verify that the processor card is of the right
type for your system and is properly
installed.
2. If only one processor card is installed,
replace it. If there are two processor cards
installed, remove the second processor card.
If the problem is resolved, replace that
processor card. If it does not resolve the
problem, swap the first processor card with
the second, just removed, processor card. If
this resolves the problem, replace the
processor card that was originally in the first
slot. If it does not resolve the problem, go to
"MAP 1540: Problem Isolation Procedures"
on page 69.
3. Go to "MAP 1540: Problem Isolation
Procedures" on page 69.
Ignore all location codes.
Go to "MAP 1540: Problem Isolation Procedures"
on page 69 and run minimum configuration.
Ignore all location codes.
Go to "MAP 1540: Problem Isolation Procedures"
on page 69 and run minimum configuration.
Inspect system memory for proper installation of
DIMMs.
1. Check cabling.
2. Set the I/O type. See Power Control Network
Utilities menu on page 272.
3. CEC backplane
Location code: U0.1-P1
1. Check cabling.
2. Set the I/O type. See Power Control Network
Utilities menu on page 272.
3. CEC backplane
Location code: U0.1-P1
1. Check cabling.
2. Set the I/O type. See Power Control Network
Utilities menu on page 272.
3. CEC backplane
Location code: U0.1-P1
Processor card
Location code: U0.1-P1-C1
Processor card
Location code: U0.1-P1-C2
Processor card
Location code: U0.1-P1-C1
Processor card
Location code: U0.1-P1-C2
Chapter 5. Error code to FRU index
133

Advertisement

Table of Contents
loading

Table of Contents