2. To check other resources, select the resource. When you have checked all of the resources that you
need to check, go to "Step 5. Stop the diagnostics".
Step 5. Stop the diagnostics
To stop the diagnostics, do the following:
1. To exit the diagnostics, press F3 (from a defined terminal) or press 99 (from an undefined terminal).
2. If you changed any attributes on your ASCII terminal to run the diagnostics, change the settings back
to normal.
3. This completes system verification. If you received an error code, record the code and report it to the
service organization.
If the system passed all the diagnostic tests, the verification process is complete and your system is ready
to use.
Chapter 7. Verifying the hardware operation
245