Otto Bock Xeno Service Manual page 91

Main Menu
Parameters
System General drive
settings
Rescue drive
Wheelchair data
Reverse beep
Timing
Motor & wheels
Registered office
Submenu Settings
Max speed The maximum speed parameter forms another layer
above the speed values that can be programmed under
input devices.
Example: Max. speed = 60%.
Forward speed = 80%. In driving mode 1: 0.8 x 60% =
48% of the maximum driving speed.
Maximum RPM Limits the maximum turning speed.
Quick stop fwd Factor that determines the deceleration, e.g. if the joystick
factor is released while driving.
Quick stop
rev factor
Emergency stop Parameter that determines the deceleration in case of
problems in the control unit, e.g. the wheelchair is turned
off while driving.
Forward tracking Compensates for speed differences between the right-hand
and left-hand motor. Directional stability can be improved.
Reverse tracking
V-steering limit Determines speed changes in curves.
Mode button Defines whether long and short mode signals have dif-
navigation ferent meanings.
Profile increase
stop
All drive parameters if the wheelchair is in an emergency
situation (creep speed).
Parameters that relate to the wheelchair base frame,
e.g. wheelbase. They should not be changed.
A warning signal can be emitted during reverse operation.
It can be activated or deactivated in the individual profiles.
Various times can be programmed.
Automatic shutoff The wheelchair turns off after the time set here. It does
not shut down if the setting is 0.
Latch timeout After the time specified here, the wheelchair switches
from cruise control operation to normal operation.
Latch timeout Specifies whether the cruise control automatically stops
deactivated after the latch timeout or not.
Drive timeout Time between the last driving command and automati-
cally switching to the prior mode. No switching if the
parameter is set to 0.
Aux timeout Time between the last input command and automatically
switching to the prior operating mode. No switching if
the parameter is set to 0.
Menu timeout Defines the command time for menu operation.
IR function Time before the IR menu jumps up one level. No jump if
timeout the parameter is set to 0.
Parameters that adapt the drive motors to the controller.
The direction of rotation can be changed.
Actuators 1 to 5 Parameters to adjust the seat actuators (speed, current).
The seat module offers a separate 12 volt output. The
voltage can be turned on or off under the "Miscellane-
ous" menu item.
91