Removing The Anti-Tipper Wheel; Lighting; Front Lights - Otto Bock Xeno Service Manual

6.7.2 Removing the anti-tipper wheel

Tools:
❒ Allen wrench, size 5 mm
❒ Ring wrench or open-end wrench, size 13 mm
Steps:
1. Loosen the Allen head screw.
2. Remove the wheel and replace if required.
Properly reassemble all components upon completion of the work.
Figure 43 Removing the anti-tipper wheel

6.8 Lighting

The Xeno power wheelchair can be equipped with optional front and rear lights. The lighting
function is controlled using the controller. The lighting is connected to the controller underneath
the seat (see Section 8.2 for connections). The controller is pre-programmed. It can be adapted
to the respective lighting system by programming it using the handheld programming device (see
Section 8.4).

6.8.1 Front lights

INFORMATION
Ensure the protective pane is properly positioned in the housing during installation. Tighten the screws
for the protective pane thoroughly so that moisture cannot penetrate the lamp.
45