Otto Bock Xeno Service Manual page 80

Display symbol(s) LCD monitor
display
Table 5 Error display
80
Error/warning / Cause
defect
Faulty connection
Communication
error (alternating between the hand control
flashing signal) device and controller.
Defective cabling,
software or hardware
Battery under Battery deep discharge
voltage
Battery over Voltage too high (after
voltage full charge and driving
downhill)
Seat tilt motor fault Faulty cabling or plug
connection, defective
actuator
Back angle
adjustment
motor fault
Lift seat motor fault
Faulty cabling or plug
connection, defective
Drive motor fault
actuator
Stand-up device
motor fault
Brake fault Open brake release/
defective brake
Emergency stop Severe fault caused by
controller, hand control
device, and/or drive mo-
tor malfunction
Measures
Check cabling/
plug connections
Charge as soon
as possible
Continue driving
slowly
Check cabling/
plug connections
Check cabling/
plug connections
Close brake
release; check
brake (e.g. the
Bowden cable)