Storage; Required Tools And Accessories - Otto Bock Xeno Service Manual

3.4 Storage

INFORMATION
If the power wheelchair is not moved for several days, permanent colour changes may occur where
the wheelchair comes into contact with the surface it is standing on. Otto Bock therefore recommends
parking the wheelchair on a suitable surface during extended periods of disuse.
The power wheelchair must be stored in an enclosed area. Remove the main fuse; otherwise,
there is a risk of deep discharge.
The storage location must be dry and have sufficient air circulation. There must not be any build-
up of humidity. The power wheelchair must not be subjected to any damaging exterior influences,
e.g. rain, snow, or strong solar radiation during storage.
Otto Bock recommends storing the Xeno power wheelchair with slightly elevated tyre pressure
and using assembly stands or wooden blocks in order to raise the tyres (completely) off the ground
in order to protect them from frost. Regularly rotating the wheels helps to prevent flat spots.

4 Required Tools and Accessories

Suitable tools and accessories for the completion of service tasks are listed below:
❒ Flathead screwdriver, blade widths: 2,5/3,5/5,5 mm
❒ Phillips head screwdriver, size: 2
❒ Reversible ratchet handle wrench and sockets, sizes: 8 – 20
❒ Open-end or combination wrenches, sizes: 8 – 13
❒ Allen wrench, sizes 2 – 6
❒ Torque wrench
❒ Socket, size 19
❒ Puller
❒ Pin punch, Ø 3 mm
❒ Plastic hammer
❒ Plastic tyre mounting lever
❒ Inner tube repair kit
❒ Side cutting pliers
❒ Sharp knife
❒ Felt-tip pen
❒ Measured rule
❒ Liquid thread lock "medium strength"
❒ Handheld Programming Device
15