Otto Bock Xeno Service Manual page 57

Changing the position of the thoracic support on the backrest
Tools:
❒ 2 x Allen wrench size 5
Steps:
1. Loosen and remove the two nuts if necessary, using the Allen wrench to hold the Allen head
screws stationary on the inside.
2. Slide the support receiver up or down along the slotted hole.
Properly reassemble all components upon completion of the work.
Figure 58 Changing the position of the backrest support
Adjusting the Height of the Support/Seat Width
NOTICE
Risk of damage to the support if not properly fixed. Ensure that when the task is complete the sup-
port is inserted far enough into the receiver to ensure that it locks in place properly.
The height of the supports is dependent on how far they can be inserted into the receiver on the
seat frame.
Tools:
❒ Allen wrench, size 2,5
Steps:
1. Loosen the set screw in the receiver.
2. Pull the support out of the receiver.
3. Loosen and remove the two Allen head screws.
4. Set the height: Slide the connection piece up or down.
5. Seat width: Turn the supports to the inside or outside.
Properly reassemble all components upon completion of the work.
57