Otto Bock Xeno Service Manual page 92

Main Menu
Parameters
Enhanced display
with Bluetooth
Wheel Lock
Actuators &
steering
Driver outputs
Light
Battery
Reset distance
Reset hourmeter
Drive-away lock
(System lock)
Configuration Save system con-
figuration
Remote control
Registered office
92
Submenu Settings
Sound & display The display is needed to control external devices using
infrared. Bluetooth can only be used to control a computer
Mouse
mouse. Bluetooth must be activated first.
Remote control
Parameters that establish when the brakes engage and
disengage.
Actuators Two actuators can be connected to the controller.
For example, speed and current values can be programmed
Servo
here.
If the actuators are intended for steering, e. g. 2 ser-
vomotors (Xeno) or 1 servomotor (C2000), they can be
programmed under servo.
J1 J1-J3 are programmable outputs. Each of them is
designed for a 2 A load and set to battery +. Program-
J2
mable parameters:
J3
External horn: Output activated by horn function
Ventilator: Output activated when the programmed
controller temperature is reached
Overvoltage: Output activated when the programmable
voltage is exceeded
Reverse motion: Output activated during reverse motion
System on: Output activated when the system is turned on
Parameters for light and direction indicator settings
Parameters for battery settings, which are very time-
consuming to establish. The default settings should
be retained.
Trip and total distance readings can be reset.
Resets the hours of operation for the drive motors.
Turns the drive-away lock function on / off.
The lock is activated when the mode button is pushed and
held for approximately 5 seconds or the corresponding
menu item is selected from the aux menu.
However, the mode button cannot be used in this manner
if the "smart button" parameter is activated, since the
long mode command is used to shut down the system
in this case.
Value: On / off.
Saves the system configuration with all modules and
checks whether all modules are present.
The menu tree for the enhanced display with Bluetooth
(LCD) can be set up here. The structure is customisable.
Actuator The existing seat actuators (functions) are assigned to
configuration the outputs in the seat module. Possible limitations can
be programmed via end switches.