Adjusting The Back Compensation - Otto Bock Xeno Service Manual

Figure 49 Changing the backrest height setting
1 Allen head screws
2 Slotted hole

6.9.3 Adjusting the Back Compensation

NOTICE
Risk of cable damage. Ensure the cables attached to the frame with cable ties are not damaged.
INFORMATION
The back compensation can be adjusted in increments of 10 mm.
Preparation:
❒ Move the seat into the standing position until the screws are freely accessible.
❒ Fold the backrest down (see Section 3.3).
Tools:
❒ 2 x Allen wrench size 5
Steps:
1. Loosen and remove the four Allen head screws.
2. Slide the mounting sheets with the horizontal sockets along the fixing holes spacer.
Properly reassemble all components upon completion of the work.
50
1
2