Seat Tilt Actuator; Replacing The Frame; Replacing The Drive Unit Support; Replacing The Drive Motor - Otto Bock Xeno Service Manual

6.10.3 Seat Tilt Actuator

CAUTION
Risk of accident and injury due to improper work on the seat tilt actuator. In order to avoid dam-
age to and malfunction of the seat tilt, installation and removal of the seat tilt actuator, may only be
performed in the facilities of Otto Bock Manufacturing Königsee GmbH.
6.11 Replacing the frame
CAUTION
Risk of accidents and injury due to improper work on the frame. In order to avoid damage and
malfunction when operating the power wheelchair, installation and removal of the frame, may only be
performed in the facilities of Otto Bock Manufacturing Königsee GmbH.
6.12 Replacing the Drive Unit Support
CAUTION
Risk of accidents and injury due to improper work on the drive unit support. In order to avoid dam-
age and malfunction when operating the power wheelchair, installation and removal of the drive unit
support, may only be performed in the facilities of Otto Bock Manufacturing Königsee GmbH.
6.13 Replacing the drive motor
CAUTION
Risk of injury due to electric current. Turn off the control unit of the power wheelchair and disconnect
all plug connections to the control unit / power module before performing any work on the drive motors.
Preparation:
❒ Remove the drive wheel (see Section 6.5.2).
❒ Remove the splash guard (see Section 6.5.10).
Tools:
❒ Allen wrench, size 6 mm
Steps:
1. Disconnect the motor connection on the controller.
2. Loosen the four Allen head screws.
3. Remove the motor and replace if required.
Properly reassemble all components upon completion of the work.
69