Adapting The Seat Cushion - Otto Bock Xeno Service Manual

Figure 59 Changing the height setting of the support

6.9.7 Adapting the Seat Cushion

The length of the seat cushion must be adapted to the seat depth.
Tools:
❒ Sharp knife
❒ Felt-tip pen
❒ Measured rule
Steps:
1. Unzip the seat cushion cover completely.
2. Pull the insert halfway out.
3. Measure the length of the insert to be cut off and mark this distance parallel to the back edge.
4. Cut off the excess from the insert with a sharp knife.
5. Replace the insert in the cover and zip the cover.
Properly reassemble all components upon completion of the work.
Figure 60 Adapting the seat cushion length
58