Otto Bock Xeno Service Manual page 52

Figure 51 Detaching the back angle adjustment actuator
2. Loosen the two Allen head screws and remove them and the washers (see Fig. 53, Items 4, 5).
3. Remove the threaded axle (Fig. 53, Item 2).
4. Slide the actuator (see Fig. 53, Item 3) along the receiver (see Fig. 53, Item 1) corresponding
to the holes, taking into consideration the values specified in Table 5.
Figure 52 Removing the threaded axle
Properly reassemble all components upon completion of the work.
52