Mounting Splash Guards For Drive Wheels (Optional) - Otto Bock Xeno Service Manual

6.5.10 Mounting Splash Guards for Drive Wheels (optional)

NOTICE
Risk of damage due to improper preparation of maintenance tasks. Use suitable objects such as
wooden blocks to secure the power wheelchair against sliding or tipping. The drive wheels must rotate
freely.
Each drive wheel has a splash guard consisting of a holding plate with 3 holes and the actual
splash guard made of plastic. The splash guard is attached to the motor mount.
Preparation:
❒ Remove the drive wheels (see Section 6.5.2).
Tools:
❒ Allen wrenches, sizes 4, 6 mm
❒ Ring wrench or open-end wrench, size 10 mm
Steps:
1. Screw the holding plate and plastic splash guard together (middle hole on the holding plate).
2. Loosen the two screws on the motor mount.
3. Place the splash guard against the motor mount so that the holes in the holding plate align
with those on the motor mount.
4. Attach the splash guard to the motor mount with two screws.
Figure 38 Installing the splash guard for drive wheels
40