Safety Instructions For Disposal; Safety Instructions For Controller Configuration - Otto Bock Xeno Service Manual

Otto bock healthcare xeno power wheelchair
Hide thumbs Also See for Xeno:
Table of Contents

Advertisement

INFORMATION
The Xeno has been tested according to EMC regulations. The following particularities must be observed
during operation and communicated to the user:
• The driving characteristics of the Xeno can be affected by electromagnetic fields (mobile phones or
other radiating devices). Therefore all mobile devices must be turned off when driving.
• The Xeno can generate electromagnetic fields that can cause interference with other devices. There-
fore, turn off the control unit whenever you do not need it.
INFORMATION
During extended periods of disuse or shipment of the XENO power wheelchair, remove the fuse from
the battery case in order to prevent deep discharge of the batteries due to standby consumption.

2.6 Safety Instructions for Disposal

CAUTION
Risk of polluting the environment with battery acid. The batteries of the power wheelchair contain
a toxic acid. They must not be disposed of with regular domestic waste and the battery acid must
not enter the sewage water system or ground. The battery manufacturer's instructions printed on the
batteries must be observed
INFORMATION
If the power wheelchair is no longer in use, it must be disposed of properly in accordance with
national regulations.
If a wheelchair is to be disposed of, all components and materials of the power wheelchair must be
recycled or disposed of properly.
2.7 Safety Instructions for Controller Configuration
WARNING
Risk of accidents and injury due to incorrect configuration settings. Modified parameter settings in
the configuration can lead to changes in driving characteristics. In particular, changes to the speed,
acceleration, braking or joystick settings can lead to unexpected and therefore uncontrollable operating
performance with a risk of accidents. Always test the driving characteristics of the power wheelchair
after configuration / programming is complete. Programming must only be completed by authorised
personnel. Neither Otto Bock nor the control unit manufacturer are liable for damages (especially
in combination with special controls) caused by programming that was not properly / professionally
adapted to the abilities of the wheelchair user.
11

Advertisement

Table of Contents
loading

Table of Contents