Replacing The Control Panel - Otto Bock Xeno Service Manual

6.15.2 Replacing the control panel

NOTICE
Loss of connection between the plug and control panel! Should the connection plug come loose during driving,
e. g. caused by vibrations, the connection to the control panel will get lost and the power wheelchair trigger an
emergency stop. When connecting the plugs, ensure that they are firmly connected to each other.
NOTICE
Cable damage! Positioning the cable incorrectly can lead to pinching and thus damage to the cable.
The cable must not be attached too tightly or too loosely. Avoid bending or squeezing the cable.
Tools:
❒ Phillips screwdriver
Steps:
1. Unplug the connection on the back of the backrest by pushing the white plastic switch up
and pulling the plugs apart.
Figure 79 Controller/control panel connector plug
2. Loosen all cable ties attaching the connection cable to armrest.
3. Pull the control panel forward out of the rail.
4. Detach the rail from the armrest.
Properly reassemble all components upon completion of the work.
73