Registered Office; Removing The Seat Cushion And Back Padding; Changing The Backrest Height Setting - Otto Bock Xeno Service Manual

Otto bock healthcare xeno power wheelchair

Hide thumbs Also See for Xeno:

Table of Contents

6.9 Registered office

CAUTION

Risk of burns in the proximity of fire. The back rest, seat bottom and supports of the XENO power

wheelchair are flame retardant but nevertheless flammable. Therefore utmost caution is required near

any sources of open flame or sparks, especially lit cigarettes.

NOTICE

Risk of damage to upholstery. During any work on the seat, the upholstery must be adequately pro-

tected against mechanical and chemical damage.

The seat cushion and back padding are attached to the seat and back plates with two hook-

and-loop closures and can simply be pulled away.

NOTICE

Risk of cable damage. Ensure the cables attached to the frame with cable ties are not damaged.

Preparation:

❒ Remove the backrest cushion from the back plate (see Section 6.9.1).

Tools:

❒ Ring wrench or open-end wrench, size 10 mm

Steps:

1. Loosen the four Allen head screws on the back side of the back plate.

2. Slide the back plate along the slotted holes to set the height.

Properly reassemble all components upon completion of the work.

Table of Contents