Replacing The Drive Wheel Flange - Otto Bock Xeno Service Manual

5. Push the valve completely through to the inside of the rim and pull out the tube.
6. Replace the tube or repair it with a conventional bicycle tube repair kit.
Properly reassemble all components upon completion of the work.
Figure 24 Removing the casing

6.5.6 Replacing the Drive Wheel Flange

Preparation:
❒ Remove the drive wheel (see Section 6.5.2).
Tools:
❒ Socket, size 19
❒ Puller
Steps:
1. Loosen the screw.
2. Use the puller to remove the wheel flange and replace if required.
Properly reassemble all components upon completion of the work.
INFORMATION
When installing the wheel, tighten all four screws to a torque of 25 Nm.
33