When "Angl" Is Selected - Sharp IV-C35M User Manual

[3] When "ANGL" is selected

ANGL NO.
Enter a register number. The register numbers
available are 0 to 15.
ANGL
Select the angle specifying method.
NO Do not select angle.
Point 1 is the point of inter section
of the two lines. Relative to the line
between points 1 and 2, the line
between points 1 and 3 will be said
3PT-
to be at a positive angle if the angle
ANGL
is measured in a counterclockwise
direction, and it will be at a negative
angle if it is measured in a
clockwise direction.
When a 2-point horizontal angle is
specified,relative to the horizontal
line, the line from point 2 that
intersects point 1 will be said to at a
2PT-H-
positive angle if the angle is
ANGL
measured in a counterclockwise
direction and at a negative angle if
it is measured in a clockwise
direction.
When a 2-point vertical angle is
specified, relative to the vertical
line, the line from point 2 that
intersects point 1 will be said to at a
2PT-V-
positive angle if the angle is
ANGL
measured in a counterclockwise
direction and at a negative angle if
it is measured in a clockwise
direction.
COND. 1, COND. 2,
Specify conditions for the angle that were selected in the "
ANGL EVALUATION
Specify judgment conditions for angle.
[TEST RESULT]:
[OUTPUT]:
RUN A TEST
Press the SET key to execute a test.
COND.3
When executing a test from the "
displayed here.
Specify a destination for the output of test results: "NO," "Y," or "C."
18-7
Distance and Angle Measurement
DIST&AGL COND SCREEN COND SAVE
1OBJ
ANGL
2ANGL NO.
00(0~15)
3ANGL
3PT-ANGL
4COND.1
REG NO MDL 0
5COND.2
REG NO MDL 0
6COND.3
REG NO MDL0
[TEST RESULT]
7ANGL EVALUATION -180.0~+180.0° B=
8RUN A TEST
EXEC
REGISTER NO.
DISTANCE
+Angle ( +180.0 )
Point 2
Point 3
Point 1
Point 1
Point 3
Point 2
+Angle
Point 1
Vertical line
Point 2
+Angle
Point 1
ANGL" item.
RUN A TEST" line the result will be
RED F C1 BRT
NO
3PT-ANGL
2PT-H-ANGL
2PT-V-ANGL
[OUTPUT]
°
NO
Point 2
+Angle
(-180.0 )
Horizontal line
18