Sharp IV-C35M User Manual page 136

Degree of Match Inspection
When a vertical line is selected
Specify the start and end points on the Y
axis. Specify the start and end points
using the up/down/left/right arrow keys.
The points will move along the Y axis
(while keeping the same X coordinate).
5
Register a reference image
After setting the reference image area, store
an image in the controller as a reference
image.
Select "
down arrow keys and select "REG" from the
popup menu.
SEARCH ARE
Specify the search area (inside the dotted
lines) on the "
using the same procedures used for setting
the reference image area.
Note: Set the menu for MDL1. Setting
REFERENCE IMG" using the up/
SEARCH ARE (MDL0)" line,
procedures are the same as MDL0.
Setting screen (Y-LINE)
Y-LINE RESET RETURN
MDL 0
1
2
3MOVE
4REFERENCE IMG
Crosshair cursor
(detection coordinate)
Solid line (reference line)
Dotted line (search line)
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
RECTANGLE RESET RETURN
MDL 0
1
2
3MOVE
4REFERENCE IMG
SET=DECISION ESC=BACK SEL=CHNG IMG TRG=FUNC
RECTANGLE RESET RETURN
MDL 0
1
2
3MOVE
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
5-6
RED F C1 BRT
SERIAL NO.
8F053G26
MODEL
IV - C35M
X:194 Y:344
RED F C1 BRT
CONTRAST SRCH
REG
DISP
SERIAL NO. SERIAL NO.
8F053G26 8F053G26
MODEL MODEL
IV - C35M IV - S30MX
SERIAL NO. SERIAL NO.
X:224 Y:208
8F053G26 8F053G26
MODEL MODEL
IV - S30MX IV - C35M
RED F C1 BRT
SERIAL NO. SERIAL NO.
8F053G26 8F053G26
MODEL MODEL
IV - C35M IV - S30MX
X:224 Y:139