Table of Contents
Advertisement
Setting Measurement Conditions
3-2 Shared settings
[1] Camera selection
Specify which cameras to use (Camera 1, Camera 2) in "MEA-CND" on the "OBJECT TYPE COND"
screen for each object type.
SELECT CAMERA
3
CAM1&2
CAM1&NG-IMG
Note: Before choosing the NG screen, you will first have to change Camera 2 to NG screen.
For details, see page 1-17.
When the select camera is changed from "CAM1&2" to "CAM1&NG-IMG," the setting details for
"MEASURE0 CAM2" and "MEASUREMENT1 to 4" are initialized.
Setting method
To set the output to the monitor, select "
TOR OUTPUT" on the "TYPE RUN COND" screen.
1. On the "OBJECT TYPE COND" screen, select
"TYPE00" and "TYPE RUN COND."
2. On the "TYPE RUN COND" screen, select
"
MONITOR OUTPUT." Then, select "NG-
IMGS" from the popup men.
Camera 1 and camera 2 can be used for measurements (0 to 4) and for
image pre-processing.
Only camera 1 can be used for measurements (0 to 4) and image pre-
processing. Using camera 1, NG images can be displayed on the monitor.
- See page 1-19.
MONI-
3-4
Description
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
+
MEA-CND(CAMERA1)
MEA-CND(CAMERA2)
FINAL NUM.CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
TYPE(NEW)
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
TYPE RUN COND SCREEN SAVE
1MONITOR OUTPUT
NG IMGS
2CAPTURE IMG
PARTIAL-IMG
3MESSSAGE DISPLAY YES(NUMERIC)
4PATTERN DISPLAY
YES
5SHOW BINARY IMG
YES
6SOW q FIX IMG
YES
7OPS MAIN DISP
YES
8DISP CHG-EVAL
NO
9PC-MNTR
NO
0THROUGH DISPLAY NO
qEXTERNSION FUNC. NO
SET=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
COLOR F C2 BRT
1MONITOR OUTPUT
2CAPTURE IMG
3MESSAGE DISPLAY
4PATTERN DISPLAY
5SHOW BINARY IMG
6SHOW q FIX IMG
7OPS MAIN DISP
8DISP CHG-EVAL
9PC-MNTR
0THROUGH DISPLAY
qEXTENSION FUNC.
wDISPLAY+CURSOR 1
eCLOSS CURSOR COORD
rDISPLAY+CURSOR 2
tCLOSS CURSOR COORD
COLOR F C2 BRT
CAM1
NG IMGS
CAM1&NG-IMG(HORIZ)
CAM1&NG-IMG(VERT)
Advertisement
Table of Contents
Troubleshooting
