Sharp IV-C35M User Manual page 177

How to set the register conditions
How to enter the REG-COND setting screen
There are three methods for getting to the REG-COND setting screen.
1) On the "MEA-CND" setting screen, move the
cursor to the " BIN AREA COND" and
press the SET key. The cursor will move into
the table. Move the cursor to the " " column
and press the SET key.
Note: If you press the SET key in the "X"
column, the setting will be invalid.
2) On the "MEA-CND" setting screen, press the
TRG/BRT key to move the cursor to the upper
function menu. Select the "COND" item and
then select the "REG COND" item and press
the SET key.
3) On the menu tree, move the cursor to the
"MEAS CND" item, and press the right arrow
key. The sub menu which contains the "REG
COND" item will appear. Move the cursor to
this item and press the SET key.
Set the register conditions
REGISTER NO.
The currently selected register number is
displayed.
If you want to set the measurement
conditions for a different register number,
press the SET key to highlight the register
number currently selected. Then press the up
and down arrow keys to select the register
number whose measurement conditions you
want to set. Press the SET key to confirm
your selection.
Note: When the "BINARY-IMG-MASK" or the
MEA-CND
1MEAS SHAPE
2MEAS AREA
3THRESHOLD
4INVERT B/W
"POLYGON" is
selected at " WINDOW" on the "MEA-CND" screen, the "
NO." line will not be displayed and the other item numbers are decrement
by one since the register number for "BINARY-IMG-MASK" and
"POLYGON" is fixed.
10-5
Object Identification by Binary Conversion
MEA-CND SCREEN COND SAVE
1MEAS GRAV CENTER
NO
2
3REGISTER NO.
0(0 3)
4REGISTER EXIST
YES
5LABEL ORDER
SCAN-ORDER
6AX.ANGL
NO
7FILT
NO
8CIRC-L
NO
9MID-PNT
NO
REGISTER NO.
0BIN AREA COND
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-DEVIATION
MEAS01(LABEL-BIN-OBJ F)
IMG PRE-PROC
MEAS CND
REG-COND
EVALUATION COND
NUM-CALC
OUT-COND
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
REG COND SCREEN COND SAVE DETAIL
1REGISTER NO.
2MEAS SHAPE
RECTANGLE
3MEAS AREA
SET (224,208) (287,271)
4THRESHOLD
SET [U.LM255 L.LM100 (0~255)]
5INVERT B/W
NO
RED F C1 BRT
IMG PRE-PROC
REG COND
EVALUATION
DST&ANGL
NUM-CALC
OUT
COLOR F C1 BRT
10
1REGISTER NO.
2MEAS SHAPE
3MEAS AREA
4THRESHOLD
5INVERT B/W
RED F C1 BRT
RECTANGLE
CIRCLE
ELLIPSE
NO
YES
REGISTER